Screw Anchor Pull-Out Forces - Paramondo 2000 Montageanleitung

26

Screw anchor pull-out forces

Screw anchor pull-out forces
Pull-out forces state the force required for pulling a screw out of the wall. No difference is
made between the screw plus screw anchor coming out of the wall, the screw breaking or
the brickwork failing.
The pull-out forces state the maximum tensile force that may be exerted on the screw and/
or screw anchor.
The fixing material must be selected to match the fitting base, type of fitting and pull-out
forces.
The values in the table are stated in kN and express the pull-out force of the anchor
(screw / screw anchor) which is subjected to the highest tension.
The values are calculated for an anchor in unbroken concrete.
The selection of the most suitable fixing material depends on the type of fitting base and its
physical condition. The fitter is responsible for checking the fitting base prior to fitting the
awning.
The screw anchor pull-out forces are calculated on the basis of Wind Resistance Class 1 in
accordance with the EN 13561 and EN 1932 standards.
Extraction load on anchoring devices
(kN)
100
XXX
150
cm
200
Extraction load on anchoring devices
(kN)
100
XXX
150
cm
200
WALL BRACKET INSTALLATION
100
0,04
0,05
0,05
BASE PLATE INSTALLATION
100
0,69
1,12
1,60
www.paramondo.de
XXX
cm
150 200
0,05 0,06
0,06 0,07
0,06 0,07
XXX
cm
150 200
0,77 0,86
1,30 1,50
1,92 2,29
250 300
0,08
0,09 0,10
250 300
1,74
2,70 3,16