Srew Anchor Pull-Out Forces - Paramondo Basic 2000 Montageanleitung

32
Screw anchor pull-out forces
Screw anchor pull-out forces
Pull-out forces state the force required for
pulling a screw out of the wall. No difference
is made between the screw plus screw an-
chor coming out of the wall, the screw brea-
king or the brickwork failing.
The pull-out forces state the maximum ten-
sile force that may be exerted on the screw
and/or screw anchor.
The fixing material must be selected to
match the fitting base, type of fitting and
pull-out forces.
The values in the table are stated in kN and
express the pull-out force of the anchor
(screw / screw anchor) which is subjected to
the highest tension.
The values are calculated for an anchor in
unbroken concrete.
The selection of the most suitable fixing ma-
terial depends on the type of fitting base and
its physical condition. The fitter is responsib-
le for checking the fitting base prior to fitting
the awning.
The screw anchor pull-out forces are calcu-
lated on the basis of Wind Resistance Class
1 in accordance with the EN 13561 and EN
1932 standards.
www.paramondo.de
Size from
250 cm x 150 cm
300 cm x 250 cm
350 cm x 300 cm
400 cm x 300 cm
450 cm x 350 cm
500 cm x 350 cm
550 cm x 350 cm
600 cm x 350 cm
N/Console number
Wall Ceiling
821/2 1232/2
2734/2 4101/2
3061/3 4592/3
3500/3 5250/3
4019/4 6029/4
4467/4 6701/4
4913/4 7370/4
5358/4 8037/4