Adjustment - Briggs & Stratton 1696205-01 Bedienungsanleitung

Maintenance
Control Cable Adjustment
The auger must stop within 5 seconds after the auger control is
released. If it does not, adjust the control cable. See Adjust-
ment below or contact an authorized service dealer to adjust
the control cable.
Inspection
The auger should rotate only when the auger control is engaged
and must stop within 5 seconds when the auger control is
released. If the auger does not rotate or does not stop as
described, adjust the control cable or contact an authorized
service dealer to adjust the control cable.
If the drive belt has broken, contact an authorized service dealer
to replace the belt and adjust the control cable.

Adjustment

1. Stop the engine and remove the key. See Stop the Engine.
2. Lift the cable cover (A, Figure 8) to expose the adjustment
loops (B) and the cable end fitting (C).
3. Remove the end fitting from the adjustment loop and reinstall
as follows:
• If the auger rotates while the auger control is not
engaged, lengthen the control cable by installing
the end fitting in the next lowest loop (decrease belt
tension).
• If the auger does not rotate when the auger control is
engaged, shorten the control cable by installing the end
fitting in the next highest loop (increase belt tension).
NOTE: Some slack must remain in the cable when the auger
control is not engaged.
4. Lower the cable cover into place.
5. Repeat the inspection procedure above. If the auger does not
rotate or does not stop as described, contact an authorized
service dealer to have the snowthrower inspected.
16
WARNING
Auger and Scraper Bar Maintenance
Before each use, check wear limit on rubber auger and gap
between scraper bar support and ground (see Figure 9).
• If wear limit on the rubber bar is reached, the rubber bar needs
replacing. See authorized dealer.
• If scraper bar support makes contact with the ground, the
scraper bar needs replacing. See authorized dealer.