Selecting Languages For Audio, Subtitles, And Teletext; Using Software Update; Using Auto Update; Setting Update Time - Pioneer PDP-436XDE Bedienungsanleitung

Enjoying DTV broadcasts
09
Selecting languages for audio, subtitles,
and teletext
You may manually configure language settings for audio,
subtitles, and teletext.
1
Repeat steps 1 to 4 provided for "Selecting a digital audio
format".
2
Select "Language Setting" ( /
3
Select "Primary Audio", "Secondary Audio", "Primary
Subtitle", "Secondary Subtitle" or "Teletext" ( / ).
4
Select a language ( / ).
NOTE
• The Plasma Display System automatically selects the
language based on the "Country" setting (page 30) when the
selected language for audio, subtitle, or teletext is not
available.
• You can select "DTV Setup" only when watching DTV
channels.

Using Software Update

This function downloads and updates the system's software at
the specified timing.

Using Auto Update

With this function on, the Plasma Display System checks if
updated software is available and then downloads it (as
necessary). After this, the system executes Add New Channels
operation (page 40). This series of operations are automatically
executed at the specified time.
1
Press HOME MENU.
2
Select "Setup" ( /
3
Select "DTV Setup" ( /
4
Select "Software Update" ( /
5
Select "Auto Update" ( / ).
6
Select "On" ( / ).
Software Update
Auto Update
Set Update Time
Start Manual Update
Technical Information
44
En
then ENTER).
then ENTER).
then ENTER).
then ENTER).
On
NOTE
• We recommend that you normally select "On".
• For Auto Update to start, there must be more than 1 hour left
to the start of the next preset recording/watching.
• 60 seconds before the scheduled update, a message prompt
appears asking if you want to carry out Auto Update or not.
Auto Update automatically starts if "OK" is selected or no
selection is made after 50 seconds.
• To quit an update in progress, press HOME MENU.
• You can select "DTV Setup" only when watching DTV
channels.

Setting Update Time

You can set the time your Plasma Display System performs
Auto Update each day. To use this function, set "Auto Update"
to "On" first.
1
Repeat steps 1 to 4 provided for "Using Auto Update".
2
Select "Set Update Time" ( /
3
Set a time for Auto Update ( / / /
Set Update Time
Time
:
11 32

Starting Manual Update

This function allows you to manually execute Software Update.
If less than 1 hour is left to the next scheduled Auto Update or
programmed recording/watching, Manual Update cannot be
executed.
1
Repeat steps 1 to 4 provided for "Using Auto Update".
2
Select "Start Manual Update" ( /
NOTE
• For Manual Update to start, there must be more than 1 hour
left to the start of the next preset recording/watching.
• For Manual Update to start, there must be more than 1 hour
left to the start of Auto Update.
• You can select "DTV Setup" only when watching DTV
channels.
then ENTER).
or 0 – 9).
then ENTER).