Presetting Tv Programmes Using The Epg; Using Auto Channel Select And Standby Recording - Pioneer PDP-436XDE Bedienungsanleitung

Using the Electronic Programme Guide (EPG)(for DTV only)
11
Presetting TV programmes using the
EPG
Using the EPG, you can easily preset digital TV programmes for
watching (auto channel select) and recording later.
You must also adjust your recording equipment settings to
record the programme. Refer to the operation manual provided
with your recording equipment.
Using auto channel select and standby
recording
With the power to the system left on, this function
automatically selects a preset TV programme when its on-air
time comes. That way you will not miss the start of an
important TV programme because you were enjoying another
TV programme.
Even if the system is in the standby mode when the preset TV
programme's on-air time comes, the Media Receiver wakes up
and outputs AV signals for recording.
1
Press EPG.
• The EPG screen appears.
2
Select a programme to be preset ( / ,
• Select a programme not yet started.
• A setup menu appears.
• Select a programme currently on-air (then ENTER): The
EPG screen closes and a channel is tuned in.
• Select a programme currently on-air (then GREEN): The
programme can be set for recording/watching the next
time (or week) it is shown.
• Select a programme not yet started (then ENTER or
GREEN): The programme can be set for recording/
watching.
3
Select "Yes" in a confirmation dialogue box ( /
ENTER).
50
En
• The Programme Timer screen with a list of other preset
programmes information appears.
No.
01
02
03
04
05
06
07
08
09
10
• You can modify the presettings here ( / ,
ENTER).
• You can register the presettings here (
4
Press RETURN to return to the EPG screen.
then ENTER).
/
• The EPG screen updates with the new presettings.
• A red clock icon appears for the preset programme.
• A yellow triangle icon appears for overlapped
presettings.
5
Press EPG to exit the EPG screen.
With the system switched on, a channel switch alarm message
appears approximately 60 seconds before execution and the
channel is switched a short time before the start of the
programme.
NOTE
• Auto channel select is not executed when the system is in
the standby mode.
then
• Even in the standby mode, preset programmes can be
recorded as only the Media Receiver alone wakes up and
outputs AV signals when the preset time comes.
• Finish presetting operations three minutes before the start of
the programme.
• For priorities about overlapped presettings, see "Priority
rules for overlapped presettings" on page 51.
• The TIMER indicator on the front of the Media Receiver lights
up in orange when a programme is preset for recording/
watching.
• Recording may fail because of watching restrictions
imposed by the CA module.
Programme Timer
Date Time Channel
Mon.05.Jan 12:00-13:00 001 ************
Every Day 14:00-15:00 007 ***************
Every Sun 14:00-15:00 007 ***************
Mon-Fri 14:00-15:00 007 ***************
Sat, Sun 14:00-15:00 007 ***************
Wed.24.Nov 12:34
Info
/ then
or ENTER).