Moving And Unpacking; Installing The Appliance; Installation In An Upright Cabinet - hanseatic TG925HS6 Gebrauchsanleitung

Page EN-34 Start-up

Moving and unpacking

• Move the appliance using a trolley or with
the help of a second person.
• Carefully unpack the appliance and re-
move all packaging, plastic moulding, ad-
hesive strips and foam padding from the
inside, outside and back of the appliance.
To open the door when the appliance
is not plugged in, use the emergency
door opener. Press the emergency door
opener onto the right side of the door and
pull the door open.

Installing the appliance

Requirements
– The cabinet where the appliance is to be
installed must be open at the back.
– Your built-in furniture may need to be mod-
ified. If you do not have the manual skills
to do this, you should hire a professional.
– Veneers or plastic coverings on the built-
in furniture require heat-resistant adhesive
(100 °C). If the adhesive and surfaces are
not heat-resistant, the covering may warp
and come loose.
– There must be a clearance of at least
100 mm between the built-in cupboard and
the wall.
– There must be a minimum installation
height of at least 850 mm between the floor
and the appliance.
– An earthed socket must be installed in the
alcove or its immediate vicinity (see the fol-
lowing section, 'Connection').
– The appliance should not be placed direct-
ly beside a refrigerator or freezer. The heat
output unnecessarily increases their own
energy consumption.
– There must be a minimum spacing of 2 m
from radio devices and televisions, to en-
sure that the reception is not distorted.
Installation alcove
The microwave can be installed in a high cab-
inet. The following conditions must be met:
– The installation recess must have the
following minimum dimensions:
Width:
Depth:
Installation height:
Minimum installation
height:
Air inlet front/bottom
and top, respectively:

Installation in an upright cabinet

600
min.
560
+8
550
45
380 +2
850
Ventilation
grille
Ventilation inlet
min. 250 cm
2
560 mm
550 mm
380mm + 2 mm
850 mm
250 cm
2
45
C a b i n e t
legs