Safety Instructions - Camille Bauer KINAX SR709 Betriebsanleitung

Operating Instructions
KINAX SR709, Transmitter for Position Feedback

1. Safety instructions

1.1 Symbols
The symbols in these instructions point out risks and have the
following meaning:
Warning in case of risks.
Non-observance can result in malfunctioning.
Non-observance can result in malfunctioning
and personal injury.
Information on proper product handling.
1.2 Intended use
• The position feedback transmitter KINAX SR 709 (Fig. 1) is used
to measure and transmit linear displacement (stroke) on various
types of control valves and other control devices. The output is
a load independent DC signal.
• The angular position transmitter is not intended to measure
rotation speed.
• The device is intended for installation in industrial plants and
meets the requirements of EN 61010-1.
• Device versions with explosion protection may only be used in
the planned purposes. The operation in other explosive atmo-
spheres is not permissible.
• Manufacturer is not liable for any damage caused by inappro-
priate handling, modifi cation or any application not according
to the intended purpose.
1.3 Commissioning
• Installation, assembly, setup and commissioning
of the device has to be carried out exclusively
by skilled workers.
• Observe manufacturer's operating instructions.
• Check all electric connections prior to commis-
sioning the plant.
• If assembly, electric connection or other work
on the device and the plant are not carried out
properly, this may result in malfunctioning or
breakdown of the device.
• Safety measures should be taken to avoid any
danger to persons, any damage of the plant and
any damage of the equipment due to breakdown
or malfunctioning of the device.
• Do not operate the device outside of the limit
values stated in the operating instructions.
Camille Bauer
Fig. 1. Position feedback transmitter KINAX SR 709 showing the operating
lever in the lower zero position, corresponding output current 0/4 mA.
1.4 Repair work and modifi cations
1.5 Disposal
1.6 Transport and storage
Operating Instructions SR709 Be – 03.13
II 2 G
• Operation of device versions with explosion
protection is only permissible when...
- the details on the type label of the device
match the on-site conditions for the permis-
sible Ex area in use (group of equipment,
equipment category, zone, temperature
class or maximum surface temperature)
- the details on the type label of the device
match the electrical supply network
- the device is undamaged and
- it has been checked that there is no explo-
sive atmosphere, oils, acids, gases, vapors,
radiation etc. present during installation.
Repair work and modifi cations shall exclusively
be carried out by the manufacturer. In case of
any tampering with the device, the guaranty claim
shall lapse. We reserve the right of changing the
product to improve it.
The disposal of devices and components may
only be realised in accordance with good pro-
fessional practice observing the country-specifi c
regulations.
Transport and store the devices exclusively in
their original packaging. Do not drop devices or
expose them to substantial shocks.
11