Technical Data; Turning The Pew Soft Interchangeable Inserts - Schunk Pronto Montage- Und Betriebsanleitung

6
Supporting jaw
Size
Max. workpiece un-
clamping length
Max. workpiece weight
Workpiece hardness
Max. permissible total
clamping force
Per chuck jaw
Max. permissible
speed
7
Fig. 2
Technical data / Turning the PEW soft interchangeable inserts

Technical data

TRP-M / Z
200 250 / 315
2.5 x D 2.5 x D
250 kg 300 kg
≤ 50 HRC ≤ 50 HRC
110 kN 180 kN
36.6 kN 60.0 kN
3000 rpm 3000 rpm

Turning the PEW soft interchangeable inserts

PEW clamping inserts (PRONTO soft inserts) are used for precision
machining or for gentle second clamping. These can be turned to
match the specific application.
There are circular machined surfaces on the top of the interchange-
able inserts (PEW). These machined surfaces can be used to attach
numerical stamps. This way, the interchangeable inserts can always
be matched to the corresponding supporting jaw.
Change clamping insert:
Screw the supporting jaw onto the chuck. Observe the tightening
torque for the mounting screws and the position of the T-nuts (they
TRP-G
200 250
2.5 x D 2.5 x D
250 kg 300 kg
≤ 50 HRC ≤ 50 HRC
80 kN 115 kN
26.0 kN 38.0 kN
3000 rpm 3000 rpm
03.00|Quick-Change Jaw System |en
315
2.5 x D
300 kg
≤ 50 HRC
160 kN
53.0 kN
3000 rpm
13