BestWater 66-11 Gebrauchsanweisung Seite 80

Technical information
Requirements for the tap water
Water flow pressure minimum
Water flow pressure maximum
Water temperature
pH value
Iron content
Salinity
If the shown values and/or tolerances are exceeded or undershot, this
can led to damage of the BestWater system.
A loss of warranty cannot be excluded.
Stainless steel reservoir (only for Jungbrunnen 66-11)
Height
Width
Depth
Weight
Capacity
Initial pressure
Connection
pre-pressure (without water)
* The flow pressure must amount to at least 150 kPa and may not
exceed 450 kPa excess pressure. If it is higher than 450 kPa excess
pressure, a pressure reduction valve must be installed.
** The consumption data can deviate from the stated values depend-
ing on water pressure, water hardness, water inlet temperature, room
temperature, fluctuations in the mains voltage and selected additional
functions.
80
Downloaded from www.Manualslib.com manuals search engine
150 kPa (1.5 bar)*
450 kPa (4.5 bar)*
5 ºC - 35 ºC
6,5 - 9,5
< 0.2 mg/l
< 3500 µS
385 mm
280 mm
280 mm
3 kg
approx. 10 - 12 litres**
0.4 - 350 kPa (3.5 bar)**
3/8" JG-Quick connector
0.3 - 0.5 bar