Initial Commisioning - BestWater 66-11 Gebrauchsanweisung

Correctly install and connect the
device before the initial commis-
sioning. Please observe the chapter
"Installation and
At this BestWater-System
a complete functional test, a seal-
ing test and a performance test
was carried out. Therefore, a resid-
ual amount of water is left behind
in the BestWater
The commissioning
After every filter change or a new
installation, the system must be put
into operation. For this purpose,
select the operating mode IB program
- commissioning program in the
operating mode menu.
Navigate with the (+) or (–)-key. To
activate the operating mode, press the
OK-key.
Digital X-Pro 20b Controller
IB Program
ESC < -
A B
This operating mode assumes that
the system is correctly installed and
connected. The water supply and the
withdrawal tap must be opened. the
commissioning can only be properly
carried out in this
Downloaded from www.Manualslib.com
connection".
system.
- > oK
ESC - +
OK
manner.
manuals search engine
Initial commissioning
In the first step, the Program rinses
the granulate material of the activated
carbon prefilters.
Digital X-Pro 20b Controller
Filter rinse
ESC < - 00030%
A B ESC -
On this occasion, the debris that might
occur during transportation is removed
and guided into a drain. Through this
method, other components are con-
served in the system.
During the membrane lavage, the jel-
ly-like is removed disinfectant from the
membrane and guided into the drain.
This process can last up to 3
Digital X-Pro 20b Controller
membran rinse
ESC < - 00078%
A B ESC -
In the last step, the Ultrapure water
side of the membrane, the energisa-
tion stages and the postfilters are
rinsed.
Digital X-Pro 20b Controller
Permeat rinse
ESC < - 00059%
A B ESC -
+
OK
minutes.
+
OK
+
OK
59