Software Updates - Jungbrunnen 66-10 / 66 - BestWater 66-11 Gebrauchsanweisung

Software updates – Jungbrunnen 66-10 / 66-11
Update of the firmware in your Best-
Water system Jungbrunnen 66-10 and
66-11.
Proceed as follows:
1. Switch off the system with the
mains switch. You will find the mains
switch at the back side of the system.
2. Pull out the cover for the interface.
You will find this on the right side be-
side the display.
Digital X-Pro 20b Controller
A B
3. Carefully insert the module with the
label MEMORY into the interface.
Digital X-Pro 20b Controller
A B
4. Now hold down the
switch on the system with the mains
Downloaded from www.Manualslib.com
ESC - +
OK
MEMORY
ESC - +
OK
OK-key
and
manuals search engine
switch. Hold down the
approx. 2 seconds. On letting go of
the green key, the following message
appears on the display:
Digital X-Pro 20b Controller
StoP
ParamEtEr
mISCEllaNEouS
mEmorY Card
A B ESC -
5. Now the system is in program
mode. Select the menu point STOP
and press the OK-key. Through this,
the current operating program is stop-
ped.
Digital X-Pro 20b Controller
ruN
ParamEtEr
mISCEllaNEouS
mEmorY Card
A B ESC -
6. To start the Update, please select
the menu point MEMORY CARD with
the (+) or (-)-keys and press the
OK-key afterwards.
Digital X-Pro 20b Controller
SaVE
SaVE & loCK KEYPad
rEStorE
A B ESC -
7. Now Select the menu point RE-
(+) or (-)-keys
STORE with the
confirm this with the
OK-key
for
MEMORY
+
OK
MEMORY
+
OK
MEMORY
+
OK
and
OK-key. Now the
77