Use
Extraction version
Fig.7
The fumes are evacuated towards
the outside through a series of
pipes (bought separately) fastened
to the supplied connecting flange.
The diameter of the exhaust pipe
must be equivalent to the diameter
of the connecting ring:
– for rectangular outlets 222 x 89
mm
– for circular outlets Ø 150 mm (*)
For more information, see the page
relative to the extraction version in
the illustrated part of this manual.
Fig.7c
Connect the product to wall-
mounted exhaust pipes and holes
with a diameter equivalent to the
air outlet (connecting flange). Using
wall-mounted exhaust pipes and
holes with a smaller diameter may
reduce the efficiency of extraction
and drastically increase noise lev-
els. All responsibility in this regard
is therefore denied.
• Use ducting with the minimal in-
dispensable length.
• Use ducting with the least possi-
ble number of curves (maximum
angle: 90°).
• Avoid drastic changes in the duct-
ing diameter.
Filtration version
Fig. 8
The extracted air will be filtered in
special grease filters and odour fil-
ters before being sent back into the
room.
The product is supplied with all
parts necessary for standard in-
stallation, with the air outlet posi-
tioned in the front part of the cabi-
net plinth.
Four high-performance ceramic
activated carbon filter packs are
already supplied with the prod-
uct. Ceramic filters are innovative
modular carbon filters, which are
regenerating (see the Maintenance
- Activated carbon filters section of
this manual).
Their chemical-physical properties
allow extremely efficient odour ab-
sorption and high mechanical re-
sistance.
For more information, see the page
relative to the filtration version (in
the illustrated part of this manual).
Fig. 13b
ENG
DE
DA
NO
SV
FI
PL
CS
SK
55