Tools Required - Sun Microsystems Sun Fire V480 Handbuch

The plastic bags of hardware contain screws and nuts that are shown below in actual
size.
10-32 Screws (8)
Any screws not used for rackmounting are spares.
Note – Bar nuts are required (but not included) for non-threaded cabinets. See the
instructions provided with your cabinet for more information.

Tools Required

Phillips No. 2 screwdriver
Set of appropriate Allen wrenches to remove the side panels on some cabinets
Adjustable wrench to tighten the nuts on the mounting brackets
Chapter 1 Installing a Sun Fire V480 Server Into a 4-Post Cabinet
M4 Screws (8) 8-32 Screws (2) 8-32 Nuts (2)
en-5