Sun Microsystems Sun Fire V480 Handbuch Seite 39

4. Connect an AC power cord to each AC inlet at the back of the server. Connect the
other end of each power cord to the power sequencer in the cabinet, or to a
grounded AC power outlet.
Note – Each outlet must connect the server to a 15A circuit for North America and
Japan, and to a 10A circuit for Europe. Consult your local electrical codes for any
additional requirements. See the instructions provided with your cabinet for
information about the power sequencer.
Note – For increased server redundancy, connect the power cords to separate
circuits.
Chapter 3 Setup Procedures en-35