Sun Microsystems Sun Fire V480 Handbuch Seite 37

Connect the Cords and Cables
Connect the cords and cables to the server as shown in the illustration.
TABLE 3-1
TABLE 3-1
Back Panel Port
One of two AC inlets for power cords
1
Ethernet ports
2
3 Serial port
4 HSSDC FC-AL port
5 USB ports
describes the ports shown in the illustration.
Back Panel Ports
5
2
3
4
1
AC inlet
Information
Connect a power cord to each AC inlet.
See "Connect the Power Cords" on page 34.
Connect a TPE cable to at least one Ethernet port. See
"Connect a Twisted-Pair Ethernet Cable" on page 37.
Use this port to set up a tip connection or to connect an
ASCII terminal. See the Sun Fire V480 Server
Administration Guide for instructions. If you are
connecting to an ASCII terminal, use an RJ-45 cable and
the DB-25 adapter (Sun Part Number 530-2889-03)
included in the ship kit.
See the Sun Fire V480 Server Administration Guide for
information about the devices you can connect to this
port.
See the Sun Fire V480 Server Administration Guide for
information about the devices you can connect to these
ports.
Chapter 3 Setup Procedures en-33
USB ports
Ethernet ports
Serial port
HSSDC FC-AL port