Sun Microsystems Sun Fire V480 Handbuch Seite 34

Inventory for Setup Procedures
You need the following components from the ship kit and the rackmounting kit to
install the cable management arm and connect the cords and cables:
Cable management arm
Power cords
Ethernet cable
Install the Cable Management Arm
This procedure describes how to attach the cable management arm to a server that
is already installed in a cabinet or a 2-post rack. For instructions on installing the
server into a cabinet, see Chapter 1. For instructions on installing the server into a
2-post rack, see Chapter 2.
1. Locate the two horizontal mounting holes on the back of the inner glide.
The cable management arm can be installed on either side of the server.
2. Align the horizontal captive screws of the cable management arm with the
corresponding mounting holes in the inner glide.
en-30 Sun Fire V480 Server Setup and Rackmounting Guide • February 2002