The discharge capacity can increase when charging with a lower
amperage.
Inserting / replacing the battery and charging
Insert the battery
To charge the battery insert the USB charging cable
appropriate end into the micro USB socket
into the USB charger adapter. When the battery
charged, the LED indicator
will flash green.
Please note the required input voltage for your torch and the output
voltage for your USB charger.
Note: Do not charge the torch
Initial use
Push the ON / OFF button
lighting mode:
100 % brightness
30 % brightness
SOS signal
OFF
Focus the beam by twisting the focus ring
clockwise.
Using the car adapter
Connect the torch
adapter
2
Plug the car adapter
car adapter
The LED will light up green as soon as the torch
charged.
or replace it as depicted in Fig. C.
3
ON / OFF button
X 1
X 2
X 3
X 4
using the USB charging cable
4
.
into the connection socket. The LED on the
2
will flash red. The torch
2
under the micro USB socket
10
during use.
4
per the chart below to switch the
8
6
4
with the
1
and the other end
9
has fully
3
clockwise or anti-
to the car
1
will charge.
has been fully
4
GB/MT
9
17