Print In Color - Rimage PrismPlus! Benutzerhandbuch

6. Select the Detect Media Change option.
•
•
7. Disable the Perfect Print option. This option is only used for the Rimage AutoPrinter.
8. Select the Media Type.
9. To save the changes, select OK.

Print in color

1. Install a multicolor ribbon in the printer. Refer to Changing the print ribbon on page 14.
2. Navigate to printing properties. Refer to page 10.
3. Select the Device Settings tab.
4. Select the Installed Ribbon setting.
5. Select Color, Three Panel CMY from the dropdown list.
6. Select the Media Type.
7. Select the Print Strobe setting and set the value from the table below.
Media Surface
DVD or Regular
Thermal white overcoat
8. Select the
•
•
9. Disable Perfect Print option. This option is only used for the Rimage AutoPrinter.
10. To make cha
Properties.
11 . Select OK, to save the changes.
110635_I
Downloaded from www.Manualslib.com
If you are using a Rimage autoloader, select No.
If you are making multiple copies on a standalone Prism, select Yes.
Note: When the Detect Media Change option is enabled, you must press the operator
button after you remove the printed disc and place a new disc on the tray.
Note: The Double Print selection is disabled when a color ribbon is selected because double print
is not available during the color printing process.
Print strobe setting for multicolor ribbon
Note: This may require multiple test printings on discs to fine-tune the color hue. Set Enable Color
Sub-Strobes to Enabled to lower an individual color's print strobe. For example, this setting can
be use d to lower the Yellow Print Strobe
disc.
Detect Media Change
If you are using a Rimage Producer system or an AutoPrinter, select
If you are making multiple copies on a standalone printer, select Yes.
Note: When the Detect Media Change option is enabled, you must press th
button after you remove the printed disc and place a new disc on the tray
nges that affect color intensity, color balance, or pattern settings, select Halftone Setup
manuals search engine
375 - 425
375 - 425
setting when trying to eliminate a halo effect on a printed
option:
Operating the Prism Printer
No .
e operator
.
11