GOK Caramatic BasicTwo Montage- Und Bedienungsanleitung Seite 19

Screw connections
If connections leak, there is a danger of explosion, fire or suffocation!
Gas may escape if the product is turned.
Do not turn the product after it has been installed and the connections have been
tightened.
Tighten connections only when they are not pressurised.
Connecting and installing hoses assemblies
Connect hoses so that mechanical, thermal and chemical stresses are avoided:
 mechanical stress: e.g. do not pull the hose assembly over sharp edges
 thermal effect: e.g. avoid open flames, radiant heat
 chemical effect: e.g. avoid grease, oil, caustic substances
Install hose assemblies so that they are not under tension (no bending and tensile strains or
torsion).
Install hose assemblies so that their connections cannot loosen unintentionally.
Connections to the pressure regulator with 90° outlet prevent the hose assembly from being
kinked.
Observe the applicable national installation regulations for LPG systems.
Application example:
Two-cylinder system Caramatic BasicTwo for operation with small cylinders
The gaskets at the inlet connections (if provided) must be replaced when re-assembling!
Make sure that the gaskets sit properly in the mounting and that the screws are tightened.
part no. 02 018 51d
Installation steps
1. Connect the inlet connectors
regulator and changeover regulator
the gas cylinder valves in such a way that the
markings "A" or "B" face upwards, if possible.
Only connect by hand, do not use tools! (Left-
hand thread!).
Inlet connector gaskets (if provided) must be
placed correctly in the socket:
2. Screw the connection hose assembly
the connection port
and the changeover regulator
thread!).
3. Screw the medium pressure hose assembly
onto the outlet connector
regulator and piping of the system (left-
hand thread!).
Tighten the connections firmly.
4. Carry out a LEAK TESTING.
Caramatic BasicTwo
of the central
of the central regulator
(left-hand
of the central
to
onto
7 / 12