Christopeit AF1 Montageanleitung Seite 18

Step 6:
Attach the hand grips (17+18) at connection tubes (21+27).
1. Put the handgrip bars (17+18) onto the connecting tubes (21+27) and
adjust the holes in the tubes so that they are aligned. (Note: the handgrip
bars must be aligned after assembly so that the upper ends are inclined
outwards (away from the support (15)).
2. Push the bolt (25) with washers (26) and spring washers (5) through the
holes and tighten the handgrip bars (17+18) at connection tubes (21+27)
firmly.
Step 7:
Attach the pulse grip bar (50) at handlebar support (15).
1. Place the pulse grip bar (50) to the support (15) and push the pulse cable
(53) through the hole of support (15) into inner top position.
2. Put the pulse grip bar (50) against the support (15) sothat the holes are
aligned. Push a spring washer (5) and a washer (6) onto each screw
M8x25 (4) and push them through the holes and tighten the pulse grip
bar (50) firmly.
18