Preparation; Installation Of The C3 Servomanager - Parker Compax3 Anleitung

Parker EME
1.2

Preparation

1.2.1.

Installation of the C3 ServoManager

Described below is the setup of a motor without load.
Installation of the C3 ServoManager .................................................................................................5
Required wiring.................................................................................................................................6
The Compax3 ServoManager can be installed directly from the Compax3 CD.
Click on the appropriate hyperlink or start the installation program
"C3Mgr_Setup_V.... .exe" and follow the instructions.
Minimum requirements
For successful installation, your PC must meet the following minimum
requirements:
Windows NT 4.0 (Intel) with Service Pack 6, Windows 2000 or Windows XP.
!
Administrator authorisation* on the system
!
Microsoft Internet Explorer 4.01 (SP2) or higher
!
Pentium-PC (300 MHz or faster is recommended)
!
64 MB RAM (128 MB recommended)
!
Required HD capacity
!
CD-Installation: 350 MB before installation, 200 MB after installation
!
Super VGA-Monitor (with a resolution of at least 800 x 600, setting: small fonts)
!
192-120112 N1 C3 Start up March 2004
Preparation
Installation of the C3 ServoManager
5