START UP
1.1
Aim of this manual
1.1.1.
Task: Setting up Compax3 , moving the motor
1.1.2.
Components required
4
You can read about the following in this chapter:
Task: Setting up Compax3, moving the motor ..................................................................................4
Required components.......................................................................................................................4
Described below is the setup of a motor without load.
Please heed the safety instructions and the device assignment in the
Compax3 installation manual (19x-120102)
Simple and independent of the Compax3 device variant
!
Without overhead for configuration
!
Without special knowledge in programming
!
Compax3 device
!
Power supply voltage
!
24 VDC voltage supply
!
Plug set
!
Motor
!
Motor cable
!
Resolver cable
!
RS232 interface cable
!
Compax3 CD
!
192-120112 N1 C3 Start up March 2004
V2 = 230V device
V4 = 400V device
230 VAC
400 VAC
24 VDC
24 VDC
ZBH 02/01
C3 Sxxx: ZBH02/02
C3 S300: ZBH02/03