Replacing Shaving Foils / Cutter Blocks - Silvercrest SFR 37 B1 Bedienungsanleitung

BB*5$ B%ERRN 6HLWH  0RQWDJ  0DL    
9. Replacing shaving foils / cutter
blocks
WARNING!
~ Do not use the device if the shaving foils|1 are damaged.
NOTE: replacement shaving foils and cutter blocks can be or-
dered (see Chapter "Ordering shaving foils / cutter blocks" on
page 21).
The shaving foils|1 and the cutter blocks|16 must be replaced, ...
... when you can see signs of damage,
... when you feel pinching when shaving or if the shave is not
close, and if this is not remedied by oiling of the shaving
foils|1 and the cutter blocks|16 (see Chapter "Cleaning and
maintenance of the device" on page 15) and
... depending on the intensity of use, but generally after one
year.
1. Figure A: press both release buttons|4 and take off the
shaving foil frame|2.
2. Figure B: press the release button|13. The shaving head|3
opens up.
3. Figure B: take an old cutter block|16 on both ends
between your thumb and index finger and pull it off the
shaver carefully. Ensure that the spring, which is located
between the cutter block and the white bracket, does not fall
out.
4. Take a new cutter block|16 on both ends between your
thumb and index finger and insert it into the white bracket
carefully. Press the cutter block right down once until it en-
gages audibly.
5. Close the shaving head|3.
17
GB