Replacing Shaving Foils/Cutter Blocks; Disposal; Removing The Battery - Silvercrest SFR 37 A1 Bedienungsanleitung

9. Replacing shaving
foils/cutter blocks
WARNING!
Do not use the device if the shaving
foils 1 are damaged.
NOTE: replacement shaving foils and cut-
ter blocks can be ordered:
- on www.hoyerhandel.com
- or at the service centre hotline (chapter
"Warranty of HOYER Handel GmbH" on
page 13)
The shaving foils 1 and the cutter blocks 12
must be replaced, ...
... when you can see signs of damage,
... when you feel pinching when shaving
or if the shave is not close, and if this is
not remedied by oiling of the shaving
foils 1 and the cutter blocks 12 (see
chapter "Cleaning and maintenance of
the device" on page 10) and
... depending on the intensity of use, but
generally after one year.
1. Figure A: press both release but-
tons 4 and take off the shaving foil
frame 2.
2. Figure B: press the release button 9.
The shaving head 3 opens up.
3. Figure B: take an old cutter block 12
on both ends between your thumb and
index finger and pull it off the shaver
carefully. Ensure that the spring, which
is located between the cutter block and
the white bracket, does not fall out.
4. Take a new cutter block 12 on both
ends between your thumb and index
finger and insert it into the white brack-
et carefully. Press the cutter block right
down once until it engages audibly.
5. Close the shaving head 3.
6. Press the new shaving foil frame 2
down on the shaving head until it
engages audibly.

10. Disposal

Removing the battery

• This device is operated with a re-
chargeable lithium-ion battery, which
you must remove before disposing of
the device.
• You must be technically minded to re-
move the battery, otherwise there is the
danger of injuring yourself. If you do not
have any experience with tools, you
should have the battery removed by a
person who is qualified to do this.
DANGER from batteries!
Ensure that the battery is not damaged
as you remove it. Fire hazard!
The removed battery must not be disas-
sembled.
Never short-circuit the battery. The con-
tacts on the removed battery must not
be connected by metallic objects. The
battery may overheat and explode.
Only remove the battery to dispose of
the device. The device is destroyed by
removing the battery. Never try to op-
erate a disassembled device.
1. Disconnect the plug-in power unit 13
from the device.
2. Switch on the device and let it run until
the battery is discharged.
3. Figure C: remove the decorative strip
on the side, along with any adhesive
residues and lever the top cover plate
off with a screwdriver.
11
GB