Legal Information - Ottobock SiOCX TF 7T450-1 Gebrauchsanweisung

7 Cleaning
CAUTION
Improper cleaning of the inner socket
Skin irritation, formation of eczema or infections due to contamination with germs and damage
to the inner socket
► Clean the inner socket daily according to the instructions given in this section.
NOTICE
Use of improper cleaning agents
Damage to the product due to use of improper cleaning agents
► Only clean the product with the approved cleaning agents.
Required cleaning agents: pH neutral soap (e.g. 453H10 Derma Clean), scratch and lint-
>
free cloth
1) Clean the product with a cloth using fresh water and a pH neutral soap.
Make sure no liquid gets onto the other prosthesis components and between the inner and
outer sockets.
2) Remove soap residue with a cloth using fresh water.
3) Dry the product with a lint-free cloth and allow it to fully air dry.
8 Maintenance
► Arrange regular maintenance intervals with the patient depending on the level of use.
► Conduct half-yearly safety inspections.
► During the standard inspection of the prosthesis components, also inspect the product.
Maintenance steps
Required materials: Allen wrench 2 mm, 646F297* isopropyl alcohol
>
1) Check the prosthetic socket for damage.
2) If present: Loosen the valve closure.
3) Mark the matching screws and insert nuts.
4) Remove the screws with the Allen wrench.
5) Take out the silicone socket.
6) If present: Remove the electrodes from the silicone socket.
7) If present: Clean the myo-contact surfaces with isopropyl alcohol.
8) Clean the prosthetic socket (see Page 13).
9) Optional: Boil the silicone socket.
10) Reassemble the prosthetic socket.
9 Disposal
This product may not be disposed of with regular domestic waste in all jurisdictions. Disposal that
is not in accordance with the regulations of the country where the product is used may have a det­
rimental impact on health and the environment. Please observe the information provided by the
responsible authorities in the country of use regarding return, collection and disposal procedures.

10 Legal information

All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.
10.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
13