Working Safely; Preparing For Use - Parkside PHKS 1450 LASER Bedienungs- Und Sicherheitshinweise

General safety advice / Preparing for use
Warning! Protecting yourself
from laser radiation:
Laser radiation
Never look directly into the beam!
Laser class 2
Maximum output power ≤ 1 mW
Wavelength: 650 nm
J
Do not look directly into the laser beam or into
the opening from which it is emitted.
J
Never direct the laser beam on to reflective
surfaces or at people or animals. Even a brief
look into a laser beam can damage your eyes.
J
Never open the laser unit housing.
J
If the device is likely to remain unused for an
extended period, remove the batteries from the
laser unit battery compartment.

Working safely:

J
If a dangerous situation arises, pull the mains
plug immediately out of the mains socket.
J
Never use the device for a purpose for which it
was not intended.
J
Always keep the device clean, dry and free of
oil or grease.
J
If the saw is used whilst fixed in place on a
saw table then the saw table must have a
restart cut-out.
J
Make sure the device is switched on before
placing it against the workpiece.
J
Always work away from your body.
J
Do not saw materials containing asbestos.
J
The course of the cut must have no obstructions
above or below it.
36 GB/MT
J
The saw blade must not project more than
3 mm out of the workpiece.
J
When you are sawing, always make sure that
you do not cut through any nails, screws or the
like.
J
Do not work with the device in the overhead
position.
J
Protect the saw blade from sharp blows or
impacts and prevent it from becoming tilted.
J
When you switch off the saw, allow the blade
to slow down naturally - do not assist this
process in any way.
J
Cracked or distorted blades are not to be
used. HSS (High Speed Steel) saw blades are
not to be used.
J
Before carrying out any work on the saw,
e.g. setting the base plate etc. always pull the
mains plug out of the mains socket.
J
Never remove sawdust or splinters whilst the
saw is running.
J
Have a suitable, tested vacuum removal device
attached to the saw when working with woods
or materials that create dusts that may be
hazardous to health.
J
Always use the safety devices integrated into
the circular saw, e.g. the safety lock-out and
automatic blade guard.
J
Ensure that all moving parts of the saw blade
protection system function properly and all
the assemblies and components involved in
covering the saw blade are in perfect working
order.
J
Do not lock on the ON / OFF switch in hand-
guided operation.

Preparing for use

Q
The PHKS 1450 LASER circular saw has Intelligent
Power Control.
This automatic power delivery system ensures that
for a particular speed range the power output
remains constant when working on harder and
more resistant materials.