Working Safely - Parkside PHKS 1450 LASER Bedienungs- Und Sicherheitshinweise

General safety advice
WARNING! Protecting yourself
from laser radiation:
Laser beam
Do not Look into the beam!
Laser cLass 2
J
Do not look directly into the laser beam or into
the opening from which it is emitted.
J
WARNING!
aperture with optical instruments (e.g.
13 a
magnifying glass, magnifying lens, etc.) could
result in eye damage.
J
Never direct the laser beam on to reflective
surfaces or at people or animals. Even a brief
look into a laser beam can damage your eyes.
J
Do not open the laser attachment housing ex-
cept to replace the batteries (2 AAA micro, 1.5 V).
Use a suitable Phillips screwdriver to unscrew
the housing.
J
Insert the batteries observing the correct polari-
ty and screw the housing back in place.
CAUTIoN! The use of operating or adjustment
devices or other methods of working other than
those indicated in this document may lead to
exposure to hazardous radiation.

Working safely:

J
If a dangerous situation arises, pull the mains
plug immediately out of the mains socket.
J
Never use the device for a purpose for which it
was not intended.
12 GB/IE/CY
PHKS_1450_Content_LB3.indd 12
Looking at the laser output
J
Always keep the device clean, dry and free of
oil or grease.
J
If the saw is used whilst fixed in place on a saw
table then the saw table must have a restart
cut-out.
J
Make sure the device is switched on before
placing it against the workpiece.
J
Always work away from your body.
J
Do not saw materials containing asbestos.
J
The course of the cut must have no obstructions
above or below it.
J
The saw blade must not project more than
3 mm out of the workpiece.
J
When you are sawing, always make sure that
you do not cut through any nails, screws or the
like.
J
Do not work with the device in the overhead
position.
J
Protect the saw blade from sharp blows or im-
pacts and prevent it from becoming tilted.
J
When you switch off the saw, allow the blade
to slow down naturally - do not assist this proc-
ess in any way.
J
Cracked or distorted blades are not to be
used. HSS (High Speed Steel) saw blades are
not to be used.
J
Before carrying out any work on the saw, e.g.
setting the base plate etc. always pull the
mains plug out of the mains socket.
J
Never remove sawdust or splinters whilst the
saw is running.
J
Have a suitable, tested vacuum removal device
attached to the saw when working with woods
or materials that create dusts that may be haz-
ardous to health.
J
Always use the safety devices integrated into
the circular saw, e.g. the safety lock-out and
automatic blade guard.
J
Ensure that all moving parts of the saw blade
protection system function properly and all the
assemblies and components involved in cover-
ing the saw blade are in perfect working order.
J
Do not lock on the ON / OFF switch in hand-
guided operation.
30.07.2008 15:08:47 Uhr