McAfee WebShield e500 Installationshandbuch Seite 47

17. To prevent any direct management connections to the appliance, you can
18. Click Inside Networks to display the Inside Networks panel.
19. Use this panel to specify the domains or IP subnets for the internal
Installation Guide
disable the LAN2 port. To do this, select Disable under the LAN2 list.
IMPORTANT: If you are using transparency mode, do not disable
the LAN2 port.
The appliance uses two lists (Inside Networks and Outside Networks)
to determine whether the traffic passing through it has comes from an
internal or external source.
TIP: If you have specific internal subdomains that you want to be
treated as external networks, such as testing.myorg.com,
you can use the Inside Networks and Outside Networks as follows:
Inside networks:
*.myorg.com
Outside networks:
testing.myorg.com
*
networks within your organization (inside the firewall) that you want
the appliance to protect (see
specify as many networks as you want.
NOTE: If you want the appliance to protect the domain in which the
appliance is located (specified in
this domain to the Inside Networks list.
To add a network, click Add, then specify either its domain or its IP
address and subnet mask in the Add dialog box that appears. Click OK
to add it to the Inside Networks list.
Installation Guide — English
"Internal networks" on page
Step 10 on page
19). You can
35), you must add
ENG - 37