Control Panel - McAfee WebShield e500 Installationshandbuch

Control panel

C
The control panel on the bottom right-hand corner of the appliance contains
LEDs that provide system information. There is also a reset button and power
button:
Power socket
D
Use the supplied power cord to connect the appliance to a power outlet.
Installation Guide
Reset button
Restarts the appliance, simulating it being turned on and off.
Power button
Turns on the appliance, so that it is operational (the power LED is lit).
If the power button is off, the appliance is in standby mode.
When the appliance is in standby mode, its network ports remain active
but no protocols or data intended for the appliance can pass through it,
maintaining your organization's anti-virus protection.
NOTE: If the power supply switch
is in the OFF position, the appliance does not receive any power.
Overheat LED
Lights when the appliance has overheated. This can be caused by poor
airflow around the unit, or if room temperature exceeds normal
operating conditions. Listen for the noise of the appliance's fan — in the
center of the unit — to check that it is still working. If it does not appear
to be working, turn off the appliance and contact your supplier.
Network activity LEDs
Flash when there is network activity on the network ports: NIC 1 is the
LAN1 port, NIC 2 is the LAN2 port. If these LEDs flash when the power
LED is off, the appliance is in standby mode.
CD-ROM drive activity LED
Flashes when the appliance is accessing the CD in the CD-ROM drive.
Power LED
Lights when the appliance is both switched on and operational.
IMPORTANT: Ensure that the power cord is suitable for the country of
use. If it is not, contact your supplier.
Installation Guide — English
(on the back of the appliance)
E
ENG - 15