Configuring The Network Settings - McAfee WebShield e500 Installationshandbuch

Installation Guide — English

Configuring the network settings

When you have installed the appliance in the
required location and made the necessary
connections (see
the appliance's network settings (step 3).
This section describes the steps for configuring the
network settings. We recommend that you read them
before performing the actions, to ensure that you
know what is required.
If you have already gathered the required
configuration information (see
configure the appliance more quickly.
To restore or upgrade the appliance's software, see
page
If you have previously created a set of configuration
files from which you want to restore the appliance's
settings, see
Step 4 — configuring the appliance's protocol
settings — is described on
For details on the appliance's default settings, refer to
Appendix A of the Product Guide.
To configure the appliance's network settings:
1. Open the web browser on the computer that
2. In the address field — where you can type a
ENG - 32
page 28), you are ready to configure
57.
"Restoring your settings" on page
you want to use to manage the appliance.
Uniform Resource Locator (URL) to open a web
site — enter the following address:
https://<IP address>
NOTE: Ensure that you type https, not http.
page 18), you can
page 40.
McAfee WebShield e500 Appliance version 2.5
1
Gather the
configuration
information
2
Install the
appliance
3
Configure the
appliance's
network settings
4
56.
Configure the
appliance's
protocol settings
5
Back up the
appliance's
settings