McAfee WebShield e500 Installationshandbuch Seite 26

Installation Guide — English
Power supply switch
E
Use this switch to turn on the appliance, so that it receives power from the
connected power outlet.
Keyboard port
F
Connect a keyboard to this port (colored purple) only if you are going to
restore or upgrade the appliance's software; see
Monitor port
G
Connect a monitor to this port only if you are going to restore or upgrade the
appliance's software; see
LAN1 port (NIC 1)
H
The LAN1 port is an RJ-45 10/100Mbps auto-sensing Ethernet network port,
and is used to connect the appliance to your existing network. See
page 29
The LAN1 port receives and transmits the following traffic:
• Inbound and outbound protocol traffic.
• Management and log data, including the communication from the remote
web browser that you use to access the appliance's user interface. If you use
ePolicy Orchestrator software with the appliance, its communication is also
transmitted through this port.
The LAN1 port has a default IP address of 10.1.1.108 (subnet mask
255.255.255.0) to allow you to access the appliance initially across the network.
When you configure the appliance, you can do the following:
• Add new IP addresses that are valid for your network.
• Modify or disable the default IP address.
• Delete the default IP address so that it cannot be used.
ENG - 16
NOTE: If the power supply switch is in the ON position but the power
button (on the control panel
OFF position, the appliance is in standby mode.
for connection information.
NOTE: For previous versions of the WebShield appliance, the LAN1 port
was known as the data port, so you might see such references in existing
documentation.
on the front of the appliance) is in the
C
Step 2 on page 58.
McAfee WebShield e500 Appliance version 2.5
Step 1 on page 58.
Step 4 on