McAfee WebShield e500 Installationshandbuch Seite 46

Installation Guide — English
14. In System Language, select the language in which you want the
15. If the LAN IP Addresses panel is not shown, click LAN IP Addresses to
16. Use the Add buttons under the LAN1 and LAN2 lists to specify new
ENG - 36
appliance to operate.
This affects the reports and messages generated by the appliance,
excluding any text strings that you can specify or modify through the
interface. This is separate from the language used for viewing the
interface (chosen when logging on to the appliance, see
34).
display the panel.
This panel lists the IP addresses configured for the LAN1 and LAN2
ports.
IP addresses for those ports (see
You can specify multiple IP addresses for each port. The appliance adds
them to the ports when you apply your changes
The new IP addresses do not overwrite the existing IP addresses. If you
no longer want to use an IP address, you can either:
• Modify or disable the IP address — select it from the list then click
Modify. To disable it, select Disable network address.
• Delete the IP address — select it from the list then click Delete.
NOTE: We recommend that you access the appliance using
your new IP addresses (after initial configuration) before
removing the default IP addresses, to ensure that the new IP
addresses work.
If you are using the appliance in proxy mode, the LAN2 port becomes a
dedicated management port, allowing you to make a direct local
management connection.
"Network addresses" on page
(Step 27 on page
McAfee WebShield e500 Appliance version 2.5
Step 4 on page
19).
39).