Cleaning And Maintenance - Bosch ErgoMixx MSM6 Gebrauchsanleitung

10. Hold down both release buttons and
remove the base unit.
11. Turn the gear attachment anticlockwise
and remove.
12. Take out the blade.
13. Remove the Vario filter insert and Vario
holder.
14. Empty the container.
■ Clean all parts immediately after use.
X "Cleaning and maintenance" see
page 11
Whisk
For whipping cream, beating egg whites
and milk froth from hot milk (max. 70 °C)
and cold milk (max. 8 °C) as well as for
making sauces and desserts.
W Risk of scalding!
When processing hot liquids, use a tall, thin
blending receptacle.
Warning!
– Never insert the whisk into the base unit
without the gear attachment.
– Do not attach or remove the gear
attachment with the whisk until the
appliance is at a standstill.
X Fig D
1. Place the prepared food in the blender
jug or other suitable receptacle or
process in the pan used for cooking.
2. Place the gear attachment on the whisk
and press until it clicks into position.
3. Place the whisk with the gear
attachment on the base unit and press
until it clicks into position.
4. Connect the mains plug.
5. Set the required speed with the speed
control (high speed recommended)
6. Take hold of the base unit and blender
jug and press the ON button Ã.
7. Process the food with the whisk.
8. Release the ON button after processing.
Wait until the drive comes to a standstill.
9. Disconnect the mains plug.
10. Hold down both release buttons
and remove the whisk with the gear
attachment from the base unit.
11. Remove the gear attachment from the
whisk.
■ Clean all parts immediately after use.
X "Cleaning and maintenance" see
page 11

Cleaning and maintenance

The attachments and accessories used
must be thoroughly cleaned after each use.
W Risk of injury
Do not touch the sharp edges of the blades
with bare hands. To clean, only grasp by the
plastic and use a brush.
Caution!
– Do not use any cleaning agents
containing alcohol or spirits.
– Do not use any sharp, pointed or metal
objects.
– Do not use abrasive cloths or cleaning
agents.
– Never immerse the gear attachment
of the universal cutter or the gear
attachment in liquids or hold under
running water. Do not clean in the
dishwasher.
Note: When processing food such as
red cabbage or carrots, plastic parts may
become discoloured. This can be removed
with a few drops of cooking oil.
In Fig. E you will find a summary of how to
clean the individual parts.
■ Only wipe the attachment of the
universal cutter and the gear attachment
of the whisk with a soft, damp cloth and
dry off.
■ Clean the other accessory parts with a
detergent solution and a soft cloth or
sponge or place them in the dishwasher.
Clean the blades with a brush.
Subject to change without notice.
Whisk en
11