Aligning The Appliance; Changing Over The Door Hinges - Bosch KTL-Serie Gebrauchsanleitung

Aligning the appliance

The appliance must be level. If the floor is
uneven, use the front height adjustable
feet.
SW 22
Changing over the door
hinges
The door hinges can be changed over
if required by the installation location.
d
Warning
While changing over the door hinges,
ensure that the appliance is not
connected to the power supply.
Pull out the mains plug beforehand.
Tilt back the appliance (if required, place
packaging material, etc. underneath).
Proceed in numerical sequence:
1 Unscrew the screw.
2 Lift the bottom of the door and take
the door bearing out of the bracket.
3 Place height adjustable foot on the
opposite side.
4 Pull the door down slightly.
5 Unscrew the journal and screw in
on the opposite side.
6 Using two knives, remove the cover
stopper from the top of the door
and reposition on the opposite side.
7 Insert the lower door bearing into the
bearing bush on the opposite side.
Insert the door into the upper journal.
8 Lift the door slightly and insert the
door bearing into the bracket.
9 Screw on the door with the screw.
en
33