Dmx Operation; Static Gobo-Wheel; Color-Wheel - EuroLite TMH XB-280 Bedienungsanleitung

DMX operation

Setting the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 19 control channels.
However, it can also be switched to a mode with 16 channels if different functions are required. To be able to
operate the device with a DMX controller, the DMX starting address must be set. The starting address
depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the OK button until the display is lit and you can select Set with the OK button. Confirm with the
OK button.
2 Press the OK button so many times again until DMX address is indicated on the display. Confirm with
the OK button.
3 Use the buttons UP and DOWN to set the address. Confirm with the OK button.
4 In order to set the desired DMX channel mode, Press the OK button so many times again until Channel
mode is indicated on the display. Confirm with the OK button.
5 Use the buttons UP and DOWN to set the desired DMX channel mode: 16 CH (16 DMX channels) or 19
CH (19 DMX channels). Confirm with the OK button.
6 With the MENU or ENTER buttons, you can return to the main menu.
7 The DMX Mode control indicator next to the display will light up when DMX signals are being received.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
The color- and gobo-wheel positions of the following DMX protocol are arranged as shown in the
graphic.
Cold white
Light green
Light yellow
Orange red
Pink
Green
Purple red

Color-wheel

Open
Red
Magenta
Yellow
Warm white
Gobo 12
Gobo 11
Orange
Gobo 10
Light blue
Gobo 9
Blue
34/40

Static gobo-wheel

Offen/
Open
Gobo 13
Gobo 8
Gobo 7
00127924, Version 1.0
Gobo 1
Gobo 2
Gobo 3
Gobo 4
Gobo 5
Gobo 6