Installation; Installing/Replacing The Lamp - EuroLite TMH XB-280 Bedienungsanleitung

INSTALLATION

Installing/Replacing the lamp

DANGER! Electric shock caused by high voltages
Within the device there are areas where high voltages may be present. Always disconnect the
device from the mains socket prior to installing or replacing a lamp.
WARNING! Risk of burns in case of inappropriate handling of the illuminant
The illuminant reaches temperatures up to 600° C. Allow the illuminant to cool down for at least
10 minutes before starting any maintenance or replacement. Have the replacement carried out by
a specialist.
The device must only be operated with an illuminant type OSD 10 Reflector 280W discharge lamp. Do not
install illuminants with a higher wattage! Illuminants with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty. Observe the safety
instructions of the illuminant manufacturer.
The lamp life given by the manufacturer must never be exceeded. Therefore, keep records of the operating
time of the lamp and replace the illuminant in a timely manner.
Store dismantled lamps in a splinter-proof container and dispose of them properly!
During the installation do not touch the glass-bulb bare-handed!
Procedure:
1
1. Unscrew the eight housing screws (standard Philips
screws) of the projector head cover and remove the projector
head cover.
27/40 00127924, Version 1.0