Approval; Europe (Ce); Usa (Fcc) - Feig Electronic OBID i-scan ID ISC.MRU200 Montage / Installation

®
OBID i-scan
6.1

Approval

6.1.1

Europe (CE)

When properly used this radio equipment conforms to the essential requirements of Article 3 and
the other relevant provisions of the R&TTE Directive 1999/5/EC of March 99.
Equipment Classification according to ETSI EN 301 489: Class 2
6.1.2

USA (FCC)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTICE:
Changes or modifications made to this equipment not expressly approved by
FEIG ELECTRONIC GmbH may void the FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
FEIG ELECTRONIC GmbH
Installation
FCC ID: PJMMRU200
Page 51 of 52
ID ISC.MRU200
M70201-4de-ID-B.doc