Ethernet Interface (Id Isc.mru200-E) - Feig Electronic OBID i-scan ID ISC.MRU200 Montage / Installation

®
OBID i-scan

4.3.3 Ethernet Interface (ID ISC.MRU200-E)

The Reader has an integrated 10 / 100 base-T network port for an RJ45. Connection is made on
X7. With structured cabling Cat 5 cables should be used. This ensures reliable operation at
10 Mbps or 100 Mbps.
Table 4-5: Ethernet interface pinouts
Terminal Abbreviation
X7 / Pin 1
X7 / Pin 2
X7 / Pin 3
X7 / Pin 4
X7 / Pin 5
X7 / Pin 6
X7 / Pin 7
X7 / Pin 8
The prerequisite for using TCP/IP protocol is that each device has a unique address on the net-
work. All Readers have a factory set IP address..
Table 4-6: Standard configuration of the Ethernet connection
IP-Address
Subnet-Mask
Port
Note:
The readers must be connected to the network and configured one after the other. Every IP-
Address must be used only one time. Alternatively this configuration can be done with the
asynchronous interface.
FEIG ELECTRONIC GmbH
TX+ Transmit Data +
TX- Transmit Data -
RX+ Receive Data +
VETH+ n.c.
VETH+ n.c.
RX- Receive Data -
VETH- n.c.
VETH- n.c.
Network
Page 41 of 52
Installation
Description
Address
192.168.10.10
255.255.255.0
10001
ID ISC.MRU200
M70201-4de-ID-B.doc