Outputs; Optocouplers - Feig Electronic OBID i-scan ID ISC.MRU200 Montage / Installation

®
OBID i-scan

4.5 Outputs

4.5.1 Optocouplers

The transistor connections of the two optocoupler outputs, collector and emitter, are galvanically
isolated from the Reader electronics and brought out with no internal circuitry to terminal X4. The
outputs must therefore be powered with an external power supply.
Table 4-9: Optocoupler output pin configuration
Terminal Abbreviation
X4 / Pin 1
X4 / Pin 2
X4 / Pin 3
X4 / Pin 4
Fig. 4-8: Internal and possible external wiring of the optocoupler outputs
Notes:
• The outputs are configured for max. 24 VDC
•
Reversing the polarity or overloading the outputs will destroy them.
•
The outputs are intended for switching resistive loads only.
FEIG ELECTRONIC GmbH
Installation
O1-C Collector – Output 1
O1-E Emitter – Output 1
O2-C Collector – Output 2
O2-E Emitter – Output 2
OUT2
OUT1
Page 44 of 52
Description
X4
E
C
E
C
/ 30 mA.
ID ISC.MRU200
M70201-4de-ID-B.doc