First Lighting - Rizzoli RT Serie Gebrauchsanweisung

2.12 ELECTRIC CONNECTIONS (EXCEPT RT 60)
The electric connection of
cookers gives power only to the oven lamp.
The connection to AC power must be done
by experienced people and according with
existing laws. The installer is responsible
of the correct connection according with
safety rules. To make the connection, you
have to connect an electric cable to the
A
terminal board placed in the rear side of the
B C
Picture 13 - Position of the terminal board for the
connection to the network
2.13

FIRST LIGHTING

Before starting to use the thermal cooker,
remove the packaging materials in the oven
and in the wood box, remove the stickers and
remove the plastic film in which is wrapped
the plate and remove with a rag the most
of the oil on its surface. Before lighting the
thermal cooker, it must be connected to a
working heating system and water must be
present in the boiler. We suggest to make
RT thermal thermal cooker. Must be done the correct
connections of line, neutral and earth as
described in the picture. The cable and
every other electric device added must be
dimensioned for the electric load to sustain
and must not be in contact with points 50° C
hotter than ambient temperature.
B
1
2
3
Picture 14 - Terminal board for the connection to the
a first lighting of the thermal cooker just
to verify the correct installation. The first
lighting must be done with moderate fire,
using little wood broken in small pieces.
In the next lightings you can progressively
increase the load of combustible.
79
network: 1. Line 2. Neutral 3. Earth