Chimney Pot - Rizzoli RT Serie Gebrauchsanweisung

2.5 FLUE
The flue must be well isolated and circular
if possible. The flue must not have defects,
narrowings or losses. All the inspection
2.6

CHIMNEY POT

The chimney pot must have an exit section
doubled than the one of the chimney, in
order to make easier the exit of the smoke.
The chimney pot must be enough tall to
lean out over the reflow zone generated
2.7 CONJUNCTION
The conjunction of the thermal cooker to the
flue must be as short as possible and must
not have horizontal or not much inclined
parts. The counterslope parts are forbidden
and must be absolutely avoided. Near the
conjunction, inflammable materials must
not be present. The conjunction must not go
NO
Picture 6 - Examples of correct and incorrect connection of the chimney
2.8 FLUE OUTLET PREDISPOSITION
Wood fired thermal cookers are predisposed
to have flue outlets in different positions
(up, back, sides). Before connecting the
thermal cooker to the chimney you must
be sure that all the outlets you will not
doors must be closed and well sealed. The
connection of other devices to the same
chimney is not allowed.
by the roof: if you are not sure about this
contact experienced technicians. If you are
in a windy place, it might be necessary to
install windproof devices.
inside the flue. To increase the safety of the
conjunction, we suggest to install a washer
on the wall being sure that the connection
between the washer and the chimney is
walled and well sealed. Also the connection
between the thermal cooker and the
conjunction must be fixed and sealed.
NO NO
use are well closed. Eventually, you can
make modifications using the devices given
together with the thermal cooker.
75
YES