Dismantling The Appliance; Working With The Appliance; Tips For Better Use; Preparing Foods - Cuisinart MINI PREP PRO CH4DCE Bedienungsanleitung

B. DISMANTLING THE APPLIANCE
• To remove the lid, hold the base of the appliance with your left hand, grasp the lid and turn in a
clockwise direction.
• To remove the blade, pull the assembly firmly upward.
• To remove the bowl, hold the base of the unit using your left hand, grasp the handle of the bowl in
your right hand and turn in a clockwise direction while lifting the bowl from the base.

5. WORKING WITH THE APPLIANCE

All you need to do to start the process is press the desired button after having placed the
ingredients in the work bowl. As soon as you release the button, the motor will stop. The blade will
rotate automatically in the desired direction, depending on the button being pressed.
A. MIX/CHOP/PURÉE/EMULSIFY
The function uses the sharpened edge of the knife.
B. GRIND
The function uses the blunt edge of the knife.

6. TIPS FOR BETTER USE

A. PREPARING FOODS
• Cut the foods into 1.5cm pieces. The larger the pieces of food, the more time required to chop.
• To avoid inconsistent results and straining the motor, do not overload the work bowl. Generally
,food should not reach more than 2/3 of the way up the central plastic stem of the blade assembly.
IMPORTANT
• We recommend keeping a firm hold on the appliance with one hand when it is in operation to stop
it from moving.
• Never operate the processor continuously for more than 1 minute at a time.
• Always wait until the blade has stopped turning before removing the lid.
• Never try to remove the lid and the bowl at the same time.
• The lid should be removed first before removing the bowl. Empty the bowl, then remove the blade
assembly.
• Thanks to the BladeLock system, which holds the blade in place, it is possible to pour out your liquid
preparations from the bowl safely without first having to remove the blades.
B. MIX/CHOP/PURÉE
Cut the food into 1.5 cm pieces. The larger the pieces of food, the more time required to chop.
To avoid inconsistent results and straining the motor, do not overload the work bowl. Generally ,food
should not reach more than 2/3 of the way up the central plastic stem of the blade assembly.
Press and release
each time before you press it. If food gets stuck around the edges of the bowl, use the spatula to
scrape the sides of the bowl, or press
several times, making sure the food falls to the bottom of the work bowl
to reverse the motor. This helps to clean food from the
(Fig.4)
17