Parkside PWSAP 20-Li B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 48

m
CAUTION! RISK OF INJURY!
Only use accessory tools recommended
u
by the manufacturer . Using other
accessory tools and other accessories can
represent a risk of injury for you .
Only use accessory tools, which bear
u
information about the manufacturer, type
of binding, dimension and permitted
number of revolutions .
Only use accessory tools where the
u
printed rotational speed is at least as high
as what has been specified on the product
marking .
Do not use any broken, cracked, or
u
otherwise damaged accessories .
Only use flawless accessory tools .
u
Ensure that the accessory tool dimensions
u
match those of the product .
Never re-drill a locating hole which is too
u
small to make it larger .
Never use separate bushings or adaptors
u
in order to make wheels with a hole that is
too large fit the product .
Support plates or workpieces to reduce
u
the risk of kickback from a jammed wheel .
Large workpieces may bend under their
own weight . The workpiece must be
supported on both sides of the wheel, near
the wheel as well as at the edge .
Release the locking flange 12: Press and
¾
hold the spindle lock button 1 . Lift up
and rotate the tightening tab in a counter-
clockwise direction . Release the spindle lock
button (Fig . G) .
If applicable, remove the current accessory
¾
tool .
Mount the desired accessory tool onto the
¾
backing flange 11 (Fig . H) .
Press and hold the spindle lock button 1 .
¾
Lift up the tightening tab . Thread the locking
flange 12 in a clockwise direction . Use
the tightening tab to tighten the accessory
tool securely . Push down the tightening tab .
Release the spindle lock button .
˜ Switching on and off
m
CAUTION! RISK OF INJURY!
Always wear protective gloves when
handling or working with the product .
m
CAUTION! RISK OF INJURY!
Always hold the product with both hands
u
while working (Fig . J) .
m
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
tool when the product is in operation .
m
CAUTION! RISK OF INJURY!
After the product has been switched off,
u
the accessory tool continues moving for
some time . Do not touch the accessory tool
and do not attempt to brake it .
GB/IE 47