Technical Specifications - Siemens SIPART PS2 Kompaktbetriebsanleitung

2. Unplug the ribbon cable connector
3. Remove the basic electronics
the pneumatic block.
⑥
4. Loosen screw in the connection area of the positioner.
5. Insert the connector of the ribbon cable (A) into the slot as shown below.
6. Secure the EMC filter module using the screw
7. Fit the basic electronics
8. Insert the ribbon cable connector
9. In non-hazardous environment:
– Stick the supplied nameplate over the nameplate on the external position detection system
– Replace the blue cable gland
Refer to section "Scope of delivery (Page 13)", items "Nameplate for device version without explosion protection" and "Gray
cable gland".
For further information on fitting of an option module, refer to the operating instructions of the respective positioner version in
section "Installing/mounting > Installing option modules".
Procedure for connecting an external position detection system
1. Connect the three terminals of the external position detection system
①
using a cable as shown in the wiring diagram.
2. Tighten the cable glands
6 Commissioning
Refer to the detailed operating instructions of the respective positioner version for information and the corresponding safety
information to be observed when commissioning.
7

Technical specifications

7.1 Rated conditions for external position detection system
Ambient temperature
Permissible ambient temperature for operation
•
Degree of protection
1)
Climate class
Storage
•
Transport
•
SIPART PS2 external position detection system
A5E03830794-03, 09/2014
④
to the fitted potentiometer from the basic electronics
⑤
from the positioner. To this end, remove the two screws that fix the basic electronics to
⑥
⑤
back into the positioner.
④
of the EMC filter module onto the positioner basic electronics.
⑩
by the supplied gray cable gland.
⑩ ⑫
and .
loosened in the third step.
⑨
to the three terminals of the EMC filter module
In hazardous areas, observe the maximum permissible
ambient temperature corresponding to the temperature
class.
-40 ... +90 °C (-40 ... +194°F)
IP66 according to IEC/EN 60529 / NEMA 4X
According to DIN EN 60721-3-4
1K5, but -40 ... +90 °C (1K5, but -40 ... +194 °F)
2K4, but -40 ... +90 °C (2K4, but -40 ... +194 °F)
⑤
.
⑧
.
9