Mowing Procedure - Honda HRG416XB Bedienungsanleitung

MOWING PROCEDURE

Read the safety instructions before starting to mow.
Using self-propelling system (HRG466XB only):
Always release the drive clutch lever when engaging the
cutting-means control lever. If drive clutch is engaged, the
machine will move when the motor is started.
1. Start the motor and engage the cutting-means.
- While pressing the yellow button [1], push the cutting-means
control lever [2]. The cutting-means start rotating.
[1]
2. Push the drive clutch lever
completely.
3. To stop the machine
moving forward.
- Release the drive clutch
lever.
4. To stop the cutting-means
rotating.
- Release the cutting-means
control lever.
10 EN
Push by hand to propel the machine (All types):
Always release the drive clutch lever when engaging the
cutting-means control lever. If drive clutch is engaged, the
machine will move when the motor is started.
1. Start the motor and engage the cutting-means.
- While pressing the yellow button [1], push the cutting-means
control lever [2]. The cutting-means start rotating.
[1]
2. Push the handle by hand to
mow the lawn.
[2]
3. To stop the cutting-means
rotating.
- Release the cutting-means
control lever.
NOTE: It is possible to refrain from using the forward drive while
mowing in areas with a narrow surface (lanes, borders, etc.).
NOTE: The area of cut (battery duration) depends on lawn conditions,
grass density, moisture content, grass length and height of cut.
[3] Switching the machine on and off frequently during cutting will also
reduce the area of cut (battery duration).
To improve the area of cut (battery duration) it is recommended to cut
more frequently, raise the cutting height and use land drive at normal
walking pace.
This model is fitted with thermal protection device.
• Function: to prevent overheating and damage to the motor,
caused by abnormal use.
• Triggering of the protection device: when the machine is
overloaded, the power supply to the motor is shut down
[3]
immediately.
Procedure to follow when the protection device is triggered:
- Release the yellow button.
- Remove the battery pack.
- Check what caused the issue and eliminate it: cutting height too
low (grass too high and/or dense), foreign object preventing the
free rotation of the cutting-means etc.
- Allow the machine to cool down in a cool environment (for from
30 to 60 minutes).
[2]
Precautions before starting up the machine again:
- Remove the battery pack.
- Check that the cutting-means is able to move freely (using
protective gloves).
- Check the safety conditions in the surrounding area (objects on
the lawn, persons or animals in the vicinity).
- Install the battery pack.
- Enable the yellow button.
- Restart your machine and confirm the problem disappeared. If
problem remains, contact your servicing dealer.
[2]
[2]