Honda HRG416XB Bedienungsanleitung Seite 13

CUTTING-MEANS REPLACEMENT
CAUTION:
• Cutting-means balance is critical to proper machine performance.
Replace any cutting-means that is damaged or out of balance.
• Use only genuine Honda replacement cutting-means.
CUTTING-MEANS SHARPENING
CAUTION:
• To avoid weakening the cutting-means, causing it to become
unbalanced or getting a bad quality of cut, the cutting-means
should be sharpened by competent personnel at your servicing
dealer.
1. Sharpen the cutting-means cutting edges with a file. File the top
side only. Maintain the original bevel for a fine cutting edge. File
both ends evenly to maintain cutting-means balance.
2. After sharpening, test the cutting-means balance using a
screwdriver as shown above. If either side dips slightly below the
horizontal, file that side. Replace the cutting-means if it dips
excessively.
15 mm
Max.
MOTOR COOLING FINS AND BATTERY LOCATION
CLEANING
1. Clean dirt and grass from around the motor cooling fins and
battery location area with a soft, dry brush as shown in the
figure.
Battery location
Motor cooling fins
13 EN