Setting The Wake-Up Time; Switching Off The Alarm Signal - Auriol Z31163 Bedienungs- Und Sicherheitshinweise

Blinking display:
RU
EN

Setting the wake-up time

This device has two wake-up times which can be set. They are set as follows:
1. Press the MODE / SET
Alarm 1 and Alarm 2
9
2. Now set the alarm you prefer by holding down the MODE / SET
button until the hour display blinks.
20
3. Press the ▲ °C / °F
desired value.
4. Confirm your setting by pressing the MODE / SET button. Repeat step
3 to set the minutes.
Note: The displays Alarm 1 and Alarm 2 indicate that the respective
alarm is switched on.
5. Switch the alarm time on or off by pressing the ▼ ALARM ON / OFF
repeatedly until the respective display appears or goes out.

Switching off the alarm signal

Press the SNOOZE- / LIGHT button
get to SNOOZE mode. The alarm signal sounds again after approx.
5 minutes. This process can be repeated 7 times.
Language:
Russian
English
button briefly in order to get to alarm mode.
20
alternate on the display.
8
and ▼ ALARM ON / OFF buttons
17
as the alarm signal sounds to
18
to set the
16
GB/MT 59