Setting Up The Product; Stand; Wall Mount; Inserting Or Replacing Batteries - Auriol HG04706A Bedienungs- Und Sicherheitshinweise

Remove the protective foil before first use.
Remove the plastic strip sticking out of the
battery compartment

Setting up the product

CAUTION! When choosing a position for the product,
make sure that it is not exposed to direct sunlight,
vibrations, heat, cold damp or dust. Do not install
the product close to heat sources, e.g. radiators.
There is otherwise a danger that the product will
be damaged.
Take care that the product is suspended properly
if mounted on a wall. If the product falls, it could
cause injury or damage to itself or other property.
Place the product on a flat, level surface.
Do not place the product on valuable or sensitive
surfaces without suitable protection. The surfaces
may otherwise be damaged.

Stand

Open the Folding stand
product to support the product.

Wall mount

Note: You will need a drill for this step.
CAUTION! DANGER TO LIFE, RISK OF IN-
JURY AND DAMAGE TO PROPERTY! Please
read the operating and safety instructions for your
drill carefully.
Hold the product on the wall to find a suitable
position for installation.
Use a pencil if necessary to mark the required
position.
8 GB/IE/NI
.
21
on the back of the
23
DANGER OF ELECTRIC SHOCK! DANGER
OF DAMAGE TO PROPERTY! DANGER OF
INJURY! Ensure that you do not strike electrical
cables, gas or water pipes when you are drilling
into the wall. If necessary, check the wall using a
suitable detector before you drill.
Drill a suitable hole in the wall using a drill.
Push a Dowel into the hole and screw a
31
Screw into the Dowel
32
Ensure that the Screw
screwed into the Dowel
Hook the Hanger
28
Screw .
32
Do not place the product anywhere near to
sources of interference such as televisions,
computers, thick walls, etc. These may hinder
reception of the radio signal.

Inserting or replacing batteries

The battery symbol
if the batteries are too weak. Make sure you replace
the batteries at the earliest opportunity.
The product starts to receive the radio time signal
as soon as the batteries are inserted.
Note: Do not alter the position of the product during
reception of the signal. This may disrupt reception.
Radio time signal (DCF):
The DCF signal (time signal transmission) consists
of time pulses broadcast from one of the most accu-
rate clocks in the world. It is situated near Frankfurt /
Main, Germany.
Your product receives these signals under ideal
conditions up to a distance of approx. 1,500 km
around Frankfurt / Main. Reception of the radio signal
generally takes approx. 3–10 minutes.
If it does not work properly, restart the radio
signal reception process. To do this, keep the
WAVE button pressed for approx. 3 seconds.
19
.
31
is not completely
32
.
31
of the product on to the
appears in the LC display
5