Connected Devices; Led Light; D) Batteries - Reely 2147829 Bedienungsanleitung

b) Connected devices
• When turning the boat on and connecting it to the remote control, always follow the procedures outlined
in the appropriate sections of this manual. This ensures that the remote control and receiver connect
properly and that the model responds reliably to remote control commands.
• Make sure that no other models are operating on the same frequency (2.4 GHz) within range of the
remote control. Always check whether there are any other 2.4 GHz remote control systems that may
interfere with the model, otherwise you may lose control of the boat!
• Conduct regular checks to verify that the model and remote control are safe to use. Inspect the parts for
any signs of damage such as defective plug connections or damaged cables. All moving parts on the
model must run smoothly and there should be no slackness in the bearing.
• The boat battery must be fully charged before use in accordance with the manufacturer's instructions.
Ensure that the batteries in the remote control have sufficient capacity remaining (use a battery tester).
If the batteries are empty, always replace the complete set, never individual cells only.
• Always align the transmitter antenna so that the antenna tip points upwards as vertically as possible.
Otherwise, the range of the transmitter may be reduced and it will communicate less efficiently with the
remote control.
• Also observe the safety and operating instructions of any other devices which are connected to the
product.
• Select a suitable body of water to use your model. Make sure you ask the person or organisation respon-
sible for the body of water whether you are permitted to use your model there.
• Observe currents and other detrimental conditions in the selected body of water that may make opera-
tion of the model difficult or even impossible. Such conditions may cause you to lose the model!
c) LED light
• Attention, LED light:
- Do not look directly into the LED light!
- Do not look into the beam directly or with optical instruments!

d) Batteries

• Correct polarity must be observed while inserting AA batteries.
• Batteries should be removed from the device if it is not used for a long period of time to avoid damage
through leaking. Leaking or damaged batteries might cause acid burns when in contact with skin, there-
fore use suitable protective gloves to handle corrupted batteries.
• Batteries must be kept out of reach of children. Do not leave batteries lying around, as there is a risk that
children or pets swallow them.
• All batteries should be replaced at the same time. Mixing old and new batteries in the device can lead to
battery leakage and device damage.
• Rechargeable batteries must not be dismantled, short-circuited or thrown into fire. Never recharge non-
rechargeable batteries. There is a risk of explosion!
22