Install The Housing With Tear-Off Protection (Backtemper) - Honeywell BUS-2 Montage, Anschluss, Anleitung

22
5.1 Install the housing with tear-off protection (backtamper)
PCB
Mounting Pillar
Strain reliefs
for cable binder
Cable
entry
Strain reliefs
for cable binder
Strain reliefs
for cable binder
Mounting slot
• Mount the plastic housing by means of three screws.
• If required screw the tear-off protection directly to the mounting surface.
• Open marked bridges.
When the housing is lifted from the wall, the circuit board with the backtamper is retained on the
wall and the cover contact triggers.
• Place the circuit board into the holder and click it into place. Observe the position of the cover
contact,
• Attach PCB with 2 screws.
Mounting and Connection Instructions Block Lock Module BUS-2/BUS-1
Keyhole
Mounting slot
PCB
Fastener
u
arrester
u
Attachment Fasten backtamper
for PCB here
Attachment for
housing cover
Position
cover
contact
with
u
u
Attachment
for PCB
Strain reliefs
for cable binder
Cable
entry
Strain reliefs
for cable binder
Open bridges u
Strain reliefs
for cable binder
Attachment for
housing cover
Mounting slot